If you try to access an SMB 1 share from Windows 10 you may receive the following error message:
You can’t connection to the file share because it’s not secure. This share requires the obsolete SMB1 protocol, which is unsafe and could expose your system to attack. Your system requires SMB2 or higher.
You can enable SMB 1 on Windows 10 using the steps below.
Time needed: 2 minutes.
Enable SMB v1 on Windows 10 with the GUI
- Go into Windows Optional Features Window
Press Windows Key + R to bring up the run dialog and type:
optionalfeatures
- Install SMB 1 Support
From the turn Windows Features on or off Window, expand “SMB 1.0/CIFS File Sharing Support” and then check the box next to “SMB 1.0/CIFS Client”
- Click OK
The installation will now proceed and you should be able to access shares using the SMB 1 Protocol again.
If you would prefer to do a command line installation, use the following command from an elevated Powershell Prompt:
Enable-WindowsOptionalFeature -Online -FeatureName "SMB1Protocol-Client" -AllFor more information see:
https://support.microsoft.com/en-gb/help/4034314/smbv1-is-not-installed-by-default-in-windows
Leave a Reply